Position Detection by a Hall Sensor

Position Detection by a Hall Sensor

The hall sensor detects a magnetic field and outputs an analog signal proportional to its magnitude.
The output of the hall sensor is converted to an ON/OFF digital signal via a comparator and then used as the rotor position signal of the brushless motor.

The hall sensor has high durability because it detects the position without contact, but it cannot be used in all environments because it is sensitive to high temperature.
High-precision and expensive encoders and resolvers are used to detect the position of the servo motor for position control. (Some of them can detect angle degrees of one millionth.)

In the case of a 2-pole motor, it is possible to detect the rotor position every 60 degrees by arranging three-hall sensors at 120 degree intervals on the side of the stator that faces the magnetic pole of the rotor.

Chapter 3 Technical Explanation of Brushless Motor

Technical Explanation of a Brushless Motor
What is PWM?
What is an Inverter?
What is a Driver?
Position Detection by an Induced Voltage
What is a Square-Wave Drive?
What is a Sine-Wave Drive?
開啟新視窗